Waveshare ST-LINKV2 , STM Programmers & Debuggers Description 1. The ST-LINKV2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAGserial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. 2. STM8 applications use the USB full speed interface to communicate with STMicroelectronics ST Visual Develop (STVD) or ST Visual Program (STVP) software. 3. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments. Key Features 1. 5V power supplied by a USB connector 2. USB 2.0 full speed compatible interface 3. USB standard A to mini B cable 4. SWIM specific features 5. 1.65 V to 5.5 V application voltage supported on SWIM interface 6. SWIM low-speed and high-speed modes supported 7. SWIM programming speed rate: 9.7 Kbytess in low speed and 12.8 Kbytess in high speed 8. SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector 9. SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector 10. JTAG specific features 11. 1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs 12. JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector 13. Direct firmware update feature supported (DFU) 14. Status LED which blinks during communication with the PC 15. Operating temperature 0 to 50 °C Application Example Connecting the PC and STM8STM32 application board through ST-LINKV2 to establish hardware connection Connection with STM8 applications The ST-LINKV2 should be connected to the STM8 application via the SWIM cable. Two SWIM cables are delivered with the product: - SWIM flat ribbon with a standard ERNI connector at o