SLogic Combo 8 Slogic Analyzer DAPLink CKLink Debugger Tool CKLink Debugger DAP-Link Debugger UART Module Black simple

SLogic Combo 8 is a development tool that combines the functions of a logic analyzer. CKLink Debugger. DAP link debugger. and USB2UART. You can switch functions at will by pressing the button during use.When used as a logic analyzer. it supports a maximum sampling rate of 80MHZ. and can cooperate with the host computer to analyze most protocols;When used as a UART module. it supports 4 serial ports at the same time. and supports a maximum baud rate of 20M. which can adapt to most scenarios where serial ports are used;Use as CKLink or DAPLink It can be used to debug RISC-V series chips and ARM series chips. and also supports 1 serial port compatible with observing logs.SLogic function parametersLogic Analyzer: SLogic Combo 8Maximum number of channels: 8CHMaximum sampling rate: 80MTransmission bandwidth: 320Mb/sSampling mode: StreamTypical configuration: 80M@4CH 40M@8CHSignal input range: 0~3.6VHigh and low level threshold: VIH Greater than 2V VIL Less than 0.8VNote: The maximum transmission bandwidth of SLogic Combo 8 under Windows environment is 160Mb/s. and the typical configuration is 80M@2CH 40M@4CHCKLink function parametersJTAG clock rate: 16MTypical dump speed: 1200KB/sDebug serial port: up to 20MbpsDAPLink function parametersDebug serial port: up to 20MbpsTypical burning speed: 110KB/sUART function parametersHigh speed four serial portsMaximum baud rate: 2x20Mbps+2x1MbpsTotal bandwidth: 42MbpsMaterial: plasticcolour: blackPackage contents:1 x SLogic Combo 8 Slogic Analyzer1 x USB Type-C data cable1 x jump wire10 x chip clampsOnly the above package content. other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.