iCE40UP5k FPGA is used for core devicesThe 5280 unit (4-LUT+CARRY+FF) has the same FPGA resources as version and less resources than the Altera version;120 Kbit dual port RAM1 Mbit (128 KByte) single port RAM, which exceeds the internal memory capacity of the FPGA used by us, is the reason why it can support CNN;PLL, 2 x SPI, 2 x I2C hardened IPs. Two internal oscillators (10 kHz and 48 MHz) greatly the design. Eight DSP multiplier blocks are used for signal processing, such as voice synthesis and ; low power consumption for battery powered applications3 x 24 mA drives and 3 x hard IP PWM (can directly drive RGB LED lights and small current motors)Enough, fast enough memory128 Mbit (16 MB) SPI double data rate (QSPI-DDR) flashFor example, video can be mitted to LED A lot of I/O (actually, there are few pins of UP5K FPGA, they are enough)3 pins for RGB LED2 for boardOne UART port, pin and TX pin can be accessed through virtual USB serial portOne keyTwo Pmod connectors ( 16x pins)There is a Pmod (8 x pins) that can be broken off shaped LED lights3 keysSufficient resources to support the CPU soft core!picorv32pico socRISC-V and other soft coresOn board FPGA programmer and USB to serial adapterCompatible with IceStorm iceprog toolSimple, no drive required to connect with the Pmod connector and Pmod moduleThis board has three kinds of standard Pmod connectors, which can be expanded much - you can use many -made Pmod modules in the market, or you can design your own dedicated Pmod modules, for example, they developed seven segment digital tube Pmod, DIP switch Pmod, LED screen drivePmod and an -compatible output Pmod.Colour:blueMaterial:PCB+electronic componentsPackage Contents:1 x FPGA development boardOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.