DMX512 Terminator 120 Ohm XLR 3 Pin Apply to DMX512stage Lights Moving Head Light Par Lights (2PCS) DMX Terminators are made with the highest quality metals and resistors. The 120 ohm resistance stops all the poor signal, flickering and shadow signals caused by bad cables and open ended lines._x000D_ Required in any professional Lighting Application where DMX Controls are used. DMX terminators are plugged into the last light in a series._x000D_ DMX terminator XLR is a XLR connector plug with a 120 Ohm resistor inside connected to the data lines. Plug this in at the last DMX unit and the DMX source perceives the cable as endless. Otherwise reflections can be caused in the end of the cable creating problems that can be very difficult to find. Avoid this by terminating the end of the cable._x000D_ A 120 Ohm DMX512 Terminator in a XLR connector._x000D_ Use to avoid data signals being reflected from the end of the data cable._x000D_ _x000D_ Professional look._x000D_ Molded housing._x000D_ 3-Pin Male XLR._x000D_ Gold plated pins on connector._x000D_ Colour:As Shown_x000D_ Material:Stainless steel_x000D_ _x000D_ Package Contents:_x000D_ 2 x DMX512 terminal resistor_x000D_ _x000D_ Only the above package content, other products are not included._x000D_ Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm. _x000D_ _x000D_ _x000D_ _x000D_