Compression Sleeve Puller for 1/2 inch copper lines Overview This tool is designed for 1/2 inch copper water systems to remove old compression rings (ferrules) and reform the copper tube for reuse. It helps when cutting the old compression fittings is not feasible, allowing you to restore the tube end for reassembly. Key benefits Easy ferrule removal: removes old compression rings without damaging the surrounding wall, reducing the risk of wall damage during Tube reforming: restores the previously copper tube to a clean, smooth end ready for a fitting Durable construction: made from wearresistant metal for reliable performance and long life Clear fitment: specifically designed for 1/2 inch copper water compression sleeve and 1/2 inch copper tubing only Fitment and materials Fitment: Ferrule Puller for 1/2 inch copper water compression sleeve and 1/2 inch copper tubing only Material: wearresistant metal built for repeated use How it works Convenient operation: the tool facilitates pulling the pipe nut and removing a ferrule, making the process simple and controlled Leaking sleeve removal: enables replacement of leaking compression sleeves without extensive wall disruption 23 practical use scenarios Scenario 1: Replacing a leaking 1/2 inch copper compression sleeve without cutting the pipe, minimizing wall disturbance during Scenario 2: Working in tight or awkward spaces where full pipe removal is impractical, allowing ferrule removal with minimal disassembly Scenario 3: During remodeling or fixture upgrades, when you need to remove an old ferrule cleanly and restore the tube end for a compression fitting Notes Applicable only to 1/2 inch copper tubing and 1/2 inch copper compression sleeves Designed to provide a straightforward, reliable solution for ferrule removal and tube end preparation without damaging surrounding materials