Power supply mode: DC Continuous output current: 2A Input voltage: 48V Suitable motor: DC Maximum applicable motor capacity: 60W Maximum output current: 3A Interface: 1. VCC: Connect to the positive pole of DC 3.3V power supply 2. GND: Connect the negative terminal of the DC 3.3V power supply, which needs to be grounded together with the signal terminal 3. IN1-IN8: Connect to the IO port of a microcontroller or PLC 4. H/L jumper: H is high level, L is low level, and the middle is the common terminal 5. VIN: Load side power supply DC positive level, GND: Load side power supply DC negative pole 6. Connect the load terminals OUT1-OUT8 to the positive pole of the load device 7. Connect the load terminal GND to the negative terminal of the load device 1. Indicator light: 3.3V version without indicator light 2. Application scenario: The output end can control high-power DC devices such as motors, light bulbs, LED light strips, DC motors, micro-water pumps, solenoid valves, etc. PWM can be input to control motor speed, light brightness, etc. 3. The voltage range of the control terminal is DC 5VDC 48V. As the control board has not undergone high-power heat dissipation treatment, it is recommended that the single power should not exceed 60W 4. The control end and signal end are isolated by optocouplers Specifications: 3.3V version Color: As shown Material: Plastic Package Contents: 1 x 8 Channel MOS Module