Features: 1. This is an ESP8266 0.96 OLED board with all the features of a traditional ESP8266 module. 2. Seamless integration with 0.96 inch OLED display, eliminating the need for wires and breadboards. 3. The board uses I2C to connect to the OLED display through the SDA (D6/GPIO14) and SCL (D5/GPIO12) pins. 4. The module is equipped with a display template. With this board, various information and data can be displayed. 5. Display function, high resolution 128x64 with SSD-1306 driver, compatible with I2C, SPI interface, can use interface for connection, and interface can be selected according to requirements. Product parameters: Interface: Type-C Working voltage: 3.3V Input voltage: 7-12V Digital I/0 pins (DIO): 16 Analog input pin (ADC): 1 UART: 1 SPI: 1 1 12Cs:1 driver.CH340G Flash memory: 4MB SRAM: 64KB Clock Speed: 80 MHZ Microcontroller: Tensilica 32-bit RISC CPU Xtensa LX106 Module size: 59mm x 31mm Small module that can be installed intelligently in your IoT project, with onboard CH340-based USB-TTL for plug-and-play 0.96-inch SD1306 OLED parameters: OLED self-illuminates, no backlight Screen material: glass, needs good protection Size: 0.96 inches Voltage: 3.3V-5V DC Viewing angle: Greater than 160° High resolution: 128x64 Driver lC:SSD1306 I12C interface: SCL: I12C serial clock DA: l2C serial data Working temperature: -30°C~70°C Module size: 25mm x 17mm Notice: Pay attention to wiring as shown in the diagram and do not make wrong connections. This document only represents the product knowledge and parameters at the time of editing and is subject to change without prior notice. The power supply voltage should not exceed the maximum withstand voltage of the module, otherw