Features: 1. BT 4.0+2.4G wireless dual mode. 2. Built-in large-capacity battery (400mAh), support QI wireless and type C interface charging. 3. Support for Win/Mac/Android system. 4. Colorful RGB backlight. 5. DPI cycle adjustment: 800 red / 1200 blue / 1600 green / 2000 purple / 2400 yellow. 6. Intelligent power saving design - The mouse enters the standby state without operation within 3 seconds, and no operation enters deep sleep within 10 minutes. Press any key to wake up. 7. Using the original PAW3212 intelligent ultra-low power photoelectric IC, the highest 2400DPI high precision optical tracing engine. Specification: Mouse sensor reading speed: 4000 times / sec The sensor uses the LED's illuminating color: red light Power requirements: Lithium battery power supply 3.7V capacity 400MA Sensor tracking speed: 30 inches / sec Acceleration: 10G Support: type-c interface Three-stage switch control power supply and LOGO lighting The maximum temperature during charging: < 42 °C (ambient temperature: 25 °C) Package List: 1 * Mouse 1 * USB Cable 1 * USB Receiver 1 * Instruction Manual Mode switching and indication: ID button long press 3 seconds BT / 2.4G mode can switch to each other, the corresponding indicator flashes prompt. Code operation step: BT Mode: When the BT mode is switched, you can press the ID button to select any device (1, 2, 3), the corresponding indicator lights up, and the frequency flashes slowly (indicating time 3 minutes); The left, middle, and right buttons of the mouse are 3-5 seconds, and the corresponding indicator on the bottom becomes flashing. After the pairing is successful, the indicator is off. 2.4G Mode: When the 2.4G mode is switched, the blue light of the device 3 position is illuminated, indicating the time is 10 seconds; at this time, the left, middle, and right buttons of the mouse can be pressed simultaneously for 3-5 seconds, and the blue light at the bottom indicates that the light is turned into a breath. Status (indicating time 3 minutes), the receiver can be inserted into the USB host at this time, and the blue light is off after the pairing is successful. Note: 1. The mouse defaults to 2.4G mode, no need to directly use the code. When there is a code loss or can not be connected, you can refer to the 2.4G mode code operation steps. 2. If the power switch at the bottom of the mouse is directly dialed to the LED position, there will be a delay in a short time. Please dial to ON first, then to the LED. 3. When wired/wireless charging, the mouse and wireless charger sensing area is hot, which is normal. 1、Built-in large-capacity battery (400mAh), support QI wireless and type C interface charging. 2、DPI cycle adjustment: 800 red / 1200 blue / 1600 green / 2000 purple / 2400 yellow. 3、Intelligent power saving design - The mouse enters the standby state without operation within 3 seconds, and no operation enters deep sleep within 10 minutes. Press any key to wake up. 4、Using the original PAW3212 intelligent ultra-low power photoelectric IC, the highest 2400DPI high precision optical tracing engine. 5、BT 4.0+2.4G wireless dual mode.