Feature:1. Chip: Temperature humidity transmitter probe adopts for 3X series of chips, which makes the transmitter probe low power consumption and high accuracy specifications. With fully calibrated, RS485 communication interface output.2. IP67 Waterproof: Temperature humidity transmitter probe has IP67 waterproof, high temperature and low temperature resistance, etc.3. High Reliability and Stability: The temperature and humidity sensor probe has high reliability and stability. Operating voltage is DC5 to 24V.4. Light and Compact: Temperature and humidity sensor probe is small and light, easy to carry and install, does not take up too much space.5. Wide Usage: Temperature and humidity transmitter probe is suitable for food temperature measurement, smart home appliances, agriculture, industry, etc.Specification:Item Type: Temperature Humidity Sensor ProbeHousing: 304 Stainless Steel, PlasticWaterproof: IP67 WaterproofWorking Current: Less Than 10mAHumidity Accuracy: 2%RHTemperature Accuracy: 0.2Working Voltage: DC5-24VTemperature Measurement Range: -20-100Humidity Measurement Range: 0-100%RHOutput Mode: RS485 OutputWorking Conditions: -40-125, 0-99%RHStorage Conditions: -20-80, 0-95%RHLine Length: Approx. 150cm / 59inCautionAir relative humidity is a function of temperature, air temperature has a great impact on relative humidity, acids, bases, salts and other compounds have a significant impact on the physical properties of water vapors, the following matters should be noted when using:1. The temperature and humidity sensor should be installed in a relatively stable temperature, the most representative of the measured ambient temperature and humidity.2. Avoid installation in places with drastic temperature changes.3. Avoid installation in places where the air flows intensely.4. Avoid installation in dead ends where air does not flowing.5. Avoid using in the environment with salt spray.6. Avoid using in corrosive gas environment.Operating conditionsThe sensor performs normally within the recommended operating range, refer to the figure. Long term exposure to conditions outside the normal range, especially at humidity levels greater than 80%, may cause temporary drift of the signal (+3% RH after 60 hours). Upon return to normal operating conditions, the sensor will slowly self revert to the corrected state. Prolonged use under abnormal conditions will accelerate the aging of the product..Package List:1 x Temperature Humidity Transmitter ProbeNote:1. Temperature humidity transmitter probe is not an ordinary electronic component and needs to be carefully protected. Users must take this seriously.2. Prolonged exposure to high concentrations of chemical odors can cause sensor readings to drift.