1Great workman, the structure is simple and the product is relatively easy to assemble. 2Made of highquality plastic materials, strong and durable, has a long service life. 3Universal laser head, easy to install, completely replace the old one. 4Easy to use, adopt continuous operation mode, stable performance. 5Strict quality control and quality assurance, high safety factor, can be used with peace of mind. Item Type: Laser Lens ModuleMaterial: PlasticColor: As shown in the pictureBand Range: Visible lightOperation Mode: ContinuousIncentive Method: Electrical excitationWorking Substance: Free electronsLight Paths: Inner light pathsOutput Form: Power typeTransmission Signal: OC gate typeLaser head installation knowledge:1. How to judge the damage of the laser head: The damage of the laser head generally means that it does not read the disc or it is very difficult to read the disc. Some discs with poor quality cannot be read at all. When the device can normally recognize the machine, it is usually a laser head. When the above situation occurs, you only need to disassemble the laser head to check the model of the laser head, and then buy the corresponding model of bald head and install it, and the machine can be restored as new.2. How to judge the model of the laser head: Generally, there is a model on the label of the laser head or on the base. If not, you can take the picture of the bald head and send it to us, and we will have professional technicians to confirm the model for you . Please confirm the model of the laser head you need before purchasing, so as to avoid accidental shooting.3. How to install the laser head: When installing the laser head on the shelf, do not move the balancing bar on the shelf. When disassembling the laser head, you only need to adjust one screw of the balancing bar on one side, and do not adjust the other side, so as not to affect the balancing, otherwise the laser head may not read the disc. If you cant install it yourself, you can ask a professional to test the installation after purchase to avoid damage to the laser head and the machine.4. How to open the solder joints: When the laser head is from the factory, in order to prevent static electricity from damaging the laser tube, there are generally protective solder joints (a larger solder joint on the bald circuit board or on the flexible cable). The power supply pin of the laser tube is short-circuited to the ground. Before installing the bald head, it needs to be welded with an anti-static soldering iron. Heat the soldering iron to about 250C-280C, disconnect the power supply, and then open the protective point, otherwise the laser head will not be available. 1 x Laser Lens Module Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard.