["brand new and high quality\nFeatures:\nMade of high quality material, solid, durable and practical, good performance and long lasting.\nLCD screen, display information comprehensively and clearly.\nConfiguration of intelligent fan can dissipate the heat effectively and quietly.\nLoad maximum power 150W, max voltage 200V, max current 20A.\nOver voltage, over current, and over pressure alarm can protect the module from damage effectively.\nWidely used for testing various batteries, for DC power supply, and charging data lines.\n\nSpecification:\nMaterial: Fiber Glass Board, Electric Components\nSize: app.15.64 x 9.6 x 14cm/6.16 x 3.78 x 5.51in\nColor: Yellow and Purple and for Grey\nQuantity: 1 Set\n\nProduct Parameter:\nInput/Output Interface: 100A high current bite screw column\nVoltage Measurement Range: 0.00V-200V Resolution accuracy: 0.01V\nCurrent Measurement Range: 0.00A-20A Resolution accuracy: 0.01A\nCapacity Accumulation Range: 0-999.999Ah Resolution accuracy: 0.01Ah\nPower Accumulation Range: 0-9999.9Wh Resolution accuracy: 0.01Wh\nPower Measurement Range: 0000.00-180 for W Resolution accuracy: 0.01W\nImpedance Measurement Range: 1-999.9 ohms Resolution accuracy: 0.01 ohms\nTemperature Measurement Range: 0-99℃/32-210.2℉ Resolution accuracy: 1 ℃\nTiming Maximum Time: 999 hours 59 minutes 59 seconds Resolution accuracy: 1 second\nTiming Measurement Reminder Setting: countdown 24-hour arbitrary setting\nSmall Current Standby Remind Parameter and Timing: Less than 2W/0.5 hours; Over 0.5W to start timing, for DC 4-30V supplies power to the measurement system\nRefresh Time: Over 500mS/for time\nMeasurement Rate: About 0.5 times/sec\nOvervoltage and Overcurrent Setting Alarm Mode: Display warning interface to remind users\nOvervoltage Reminder Setting Range: 1-200V\nLow pressure Reminder Setting Range: 0-190V\nOvercurrent Reminder Setting Range: 0.2-100A\nDisplay Type: Micro-power LCD module LCM black font green backlight Chinese and English display\nWorking Temperature: -10 - +60℃/14 - 140℉ \nWorking Humidity: 10 - 80 (No glazed frost)\nWorking Pressure: 80 - 106kPa\n\nInstruction for Connection and Operation :\n1. Open the package, insert the power adapter into the end of the product and supply the power.\n2. Anti-clockwise rotate the two current knobs to the lower limit.\n3. Connecting the Power Supply under test to the product according to the diagram above, and the current input voltage value will be read out. Keep pressing the for key to reset all data to zero;\n4. Slowly clockwise rotate the two current knobs (coarse&fine) to adjust the current to the rating value of the Power Supply(The current should be slowly adjusted, using the fine knob priority, the coarse knob could be only used under large current condition.)\n5. When testing the battery, Low voltage discharge limit should be set up, to avoid the possible damage caused by over discharging while discharge capacity test of the battery.\n \nNote:\nNo retail package.\nPlease allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage includes:\n1 x Electronic Load Tester"]