Water flow sensor is mainly consists of plastic body, rotor assembly and hall sensor. It is installed in the hot water inlet end for water flow. When water through the flow rotor assembly, rotor will rotate and will change as the . Hall sensor output corresponding pulse and feedback to controller, then the controller will control the flow. Can be used for water heaters, credit , water vending machine, flow measurement device. Features - The water flow sensor for water heater, imprinter, automatic water machine, and other flow measuring systems applied. - With stainless steel ball inside the impeller, wear-resistant. - Applied to and from structural stress for the sealing ring, avoid licking with imported hall element, and to adopt pouring sealant to avoid to lick, and age. - Install vertical, the tilt angle should not be exceeded 5 degrees. - Medium should not 120degree. Cord Connection - Red: Positive(+) - Yellow: output. - Black: Negative(-) Specifications - Workspace: 0.3-6L / min - Water pressure: <= 0.8 MPa - Minimum nominal operating voltage: 4.5 5V - 24V - Maximum Operating : 15 mA ( 5V) - Working voltage range: 5 - 18V - Load capacity: <= 10 mA ( 5V) - Operating range: <= 80 degree centigrade - Humidity range: 35% - 90% RH ( ) - Storage : -25 - + 80 degree centigrade - Storage humidity: 25% - 95% RH - Size (L * W * H): Approx 5.8 * 3.4 * 2.7 cm - Output interface diameter: Ca. Outside 7mm, inside 3mm Package list: 1 * -S401 0.3-6L/min Water Flow Sensor Flowmeter Water Control (White)